Suzhou Electric Appliance Research Institute
期刊號: CN32-1800/TM| ISSN1007-3175

Article retrieval

文章檢索

首頁 >> 文章檢索 >> 往年索引

基于對稱分量法的融冰裝置同塔雙回線路感應電壓分析

來源:電工電氣發布時間:2022-06-21 13:21 瀏覽次數:455

基于對稱分量法的融冰裝置同塔雙回線路感應電壓分析

李成博,周啟文,劉永剛,李長偉,陳立群
(南京南瑞繼保電氣有限公司,江蘇 南京 211102)
 
    摘 要:為分析線路感應電壓對融冰裝置絕緣以及運行產生的影響,提出了采用對稱分量法進行感應電壓的分析方法,分別給出了線路靜電感應電壓和電磁感應電壓在融冰裝置接入后的等效電路,并通過 PSCAD 電磁暫態仿真軟件,對理論分析進行了驗證。結果表明,在融冰裝置接入后,由于停運線路對側短接,靜電感應電壓的正序分量、負序分量明顯減少,靜電感應電壓對于融冰裝置的絕緣和運行基本無影響;電磁感應電壓雖然會施加在融冰裝置閥組兩端,但是一般情況下,和該線路匹配的融冰裝置的額定電壓會大于該線路電磁感應電壓,因此電磁感應電壓對融冰裝置絕緣也無影響,其影響之一為在開始解鎖的時候會導致解鎖時刻稍有延遲,但解鎖后此影響會消失。
    關鍵詞: 直流融冰裝置;同塔雙回線路;靜電感應;電磁感應
    中圖分類號:TM714.2 ;TM726     文獻標識碼:A     文章編號:1007-3175(2022)06-0024-06
 
Analysis of Induced Voltage of Double-Circuit Transmission Line on Common-
Tower for Deicer Based on Method of Symmetrical Components
 
LI Cheng-bo, ZHOU Qi-wen, LIU Yong-gang, LI Chang-wei, CHEN Li-qun
(NR Electric Co., Ltd, Nanjing 211102, China)
 
    Abstract: This paper proposed the method of symmetrical components to analyze the influence of induced voltage of circuits on the insulation and operation of the deicer. This paper introduced the equivalent circuit of the electrostatic induction voltage and the electromagnetic induction after the deicer connection. In addition, it verified the theoretical analysis by using the software of PSCAD. The result showed that the electrostatic induction voltage has little impact on the insulation and operation of the deicer. After the deicer connection, the positive and negative sequence components of the electrostatic induced voltage are significantly reduced due to the opposite side of the no-operation line short-circuited. Although the electromagnetic induced voltage is imposed on terminals of the valve,the rated voltage of the deicer valve matched this line is larger than the electromagnetic induced voltage. Because of this, the electromagnetic induced voltage does not affect the insulation of the deicer. It might slightly delay from the start. After unlocking the valve,this effect disappears.
    Key words: DC deicer; double-circuit transmission line on common-tower; electrostatic induction; electromagnetic induction
 
參考文獻
[1] 中國南方電網有限責任公司. 電網防冰融冰技術及應用[M]. 北京:中國電力出版社,2010.
[2] 胡丹暉,涂彩旗,蔣偉,等.500 kV 同桿并架線路感應電壓和電流的計算分析[J] . 高電壓技術,2008,34(9) :1927-1931.
[3] 嚴偉佳,華玉良,倪衛良,等. 同桿雙回輸電線路感應電壓電流計算分析[J] . 江蘇電機工程,2010,29(1) :19-21.
[4] 曾華榮,張迅,呂黔蘇,等. 一起高壓輸電線路直流融冰感應電壓過電壓分析[J] . 南方電網技術,2011,5(4) :78-80.
[5] 郭志沖,陸佳政,余占清,等. 特高壓同塔雙回線路融冰裝置感應電壓分析[J] . 電網技術,2013,37(11) :3015-3021.
[6] DOMMEL H W. 電力系統電磁暫態計算理論[M]. 李永莊,林集明,譯.北京:水利電力出版社,1991.
[7] BAUER T, LIPS H P, THIELE G, et al. Operational tests on HVDC thyristor modules in a synthetic test circuit for the Sylmar East Restoration Project[J].IEEE Transactions on Power Delivery, 1997,12(3) :1151-1158.
[8] MATHUR R M, VARMA R K. 基于晶閘管的柔性交流輸電控制裝置[M]. 徐政,譯. 北京:機械工業出版社,2009.
[9] 王兆安,黃俊. 電力電子技術[ M ] . 北京:機械工業出版社,2005.
[10] 陸佳政,張允. 基于 12 脈動整流技術的 500 kV 輸電線路融冰裝置實現[J] . 高電壓技術,2012,38(11) :3041-3047.
[11] 王超. 輸電線路直流融冰技術研究[D] . 北京:華北電力大學,2011.
[12] 韓俊,徐政,李俠. 基于 PSCAD/EMTDC 的 24 脈波整流器模型研究[J]. 高壓電器,2010,46(12) :18-21.
[13] 趙婉君. 高壓直流輸電工程技術[M] . 北京:中國電力出版社,2004.
[14] 傅闖,許樹楷,饒宏,等. 交流輸電系統直流融冰裝置設計機及其應用[J] . 高電壓技術,2013,39(3) :705-711.
[15] 敬華兵,年曉紅. 輸電線路柔性直流融冰技術[J].高電壓技術,2012,38(11) :3060-3066.
[16] 饒宏,李立浧,黎小林,等. 南方電網直流融冰技術研究[J]. 南方電網技術,2008,2(2) :7-12.
[17] 張文亮,谷定燮,方文弟,等. 洪龍 500 kV 帶高抗同桿雙回線路間的感應作用研究[J] . 高電壓技術,2002,28(2) :10-12.
[18] 錢鑫,施圍. 同桿并架雙回路不同換位下模量分析[J]. 電網技術,2001,25(8) :24-27.
[19] 阮啟運,顧雪平,陸佳政,等. 湖南電網 220 kV 線路直流融冰問題研究[J] . 電力系統保護與控制,2011,39(9) :131-136.
[20] 譚艷軍,陸佳政,方針,等. 基于調壓整流的配網線路直流融冰方法及其裝置研究[J] . 電力系統保護與控制,2011,39(10) :126-129.
[21] 張翔,田杰,李海英,等. 適用于直流融冰裝置的基頻保護[J]. 中國電機工程學報,2010,30(34) :99-104.